Tri Tool 206B Beveler - Manual (Page 25)

25
Model 206B BEVELMASTER™
92-0211 : Rev. 050224
BASIC FEED RECOMMENDATION
Use very light feed for initial beveling or until a continuous cut is established.
This is very important for longer tool bit life when cutting through flame cut or
out of square pipe ends.
Use adequate feed, .003” (.08 mm) to .006” (.15 mm) per revolution thereafter, to
establish a continuous chip cut.
If the feed is too light, only light stringer chips will be removed.
If the feed is too heavy the drive will start to overload and the chip will start to
have a rough or torn appearance.
Stainless steel, which work hardens, must be worked with heavy enough feed to stay
under the work hardened surface, .003" (.08 mm) to .006" (.15 mm) feed.
Never allow the Tool Bit to burnish the surface.
Reduced feeds and speeds will normally minimize chatter problems.