Tri Tool 206B Beveler User Manual
Page 16
16
TRI TOOL INC.
92-0211 : Rev. 050224
NOTE:
NOTE:
Tool life may be severely shortened, unless chips and/or other debris that
have been deposited on the cutting head during the machining operation are
removed.
Verify that there is adequate grease in the gear box. Bearing and gears are to be
lubricated using a high string utility grease (P/N 68-0024).
Disassembly of a power unit voids the warranty, except when performed by a
TRI TOOL INC. designated repair technician. (A letter of designation is re-
quired.)
AIR MOTOR LUBRICATION
No direct maintenance is normally required on the air motor.
However, the air supply must flow through a filter/regulator/lubricator (FRL) unit or
separate units before arriving at the air motor.
The FRL unit must be maintained as required (frequency dependent on the basic air
supply) to keep the water trap drained, filter cleaned and the lubricator oil reservoir
filled so that a drop of oil every 2 to 5 seconds is flowing.
When the Model 206B BEVELMASTER™is to be left idle for 24 hours or more after
being run on ‘wet’ air, it is advisable to squirt oil directly into the air motor inlet and
run the motor for two (2) to three (3) seconds.