Tri Tool 206B Beveler User Manual
Page 22
22
TRI TOOL INC.
92-0211 : Rev. 050224
WARNING:
CAUTION:
Adjust the cutting speed by rotating the flow valve at the air connection.
Electric Motor
Depress the trigger.
Adjust the cutting speed by rotating the speed control dial on the trigger and/
or using the high/low switch.
Do not change the high/low switch while the motor is running. Damage to the
gears may occur.
Rotate the feed handle clockwise to bring the tool bit(s) and pipe closer to-
gether.
The actual machining operation will begin when the first tool bit contacts the
pipe.
When the pipe end is not square to the pipe axis, the tool bit will con-
tact only a small segment of the pipe during each revolution.
To avoid tool bit damage, the feed rate should be very slow until the tool bit(s)
is in contact with the pipe continually during at least one full revolution.
Continue rotating the feed handle clockwise until the end of the pipe is com-
pletely machined.
The axial feed rate of the tool bit is .0023” (.06 mm) for each graduation or
.083” (2.11 mm) for each complete revolution of the feed handle.