Tri Tool 206B Beveler - Manual (Page 19)

19
Model 206B BEVELMASTER™
92-0211 : Rev. 050224
CAUTION:
CAUTION:
Attach the tool holders in the appropriate position for the size of pipe being ma-
chined.
Use the four (4) outer holes for the larger diameters of pipe.
Use the four (4) inner holes for the smaller diameters of pipe.
Insert the tool bit(s) into the slot(s) in the tool holder(s).
The cutting edge of the tool bit(s) must be located on the radial centerline.
Insure that no tool bit is installed backwards.