Tri Tool 206B Beveler - Manual (Page 21)

21
Model 206B BEVELMASTER™
92-0211 : Rev. 050224
WARNING:
Run the Feed in and out to insure that the torque acceptance keys are not so tight
that the feed is impaired.
Re-tighten the cap screws to retain the new settings.
Rotate the feed handle clockwise to engage the feed nut with the thread on the
mandrel shaft.
A minimum of ten (10) threads must be engaged to prevent thread strippage
during the machining operation.
Verify a clearance of 1/8” (3 mm) minimum between the tool bit and the pipe face.
Make sure that there is a clearance between the tool bit(s) and the mandrel.
WARNING:
NOTE:
Air Motor: Attach the proper air supply line to the Model 206B.
Electric Motor: Plug the power cord into the proper outlet.
Check that the filter/regulator/lubricator (FRL) is installed and set properly.
MACHINING OPERATION
Do Not Override the Deadman Switch on the Unit. Locking down, obstructing,
or in any way defeating the deadman switch on this unit may result in serious
injury.
Air Motor
Depress the air motor trigger.