Tri Tool 206B Beveler - Manual (Page 18)

18
TRI TOOL INC.
92-0211 : Rev. 050224
WARNING:
NOTE:
OPERATION
Read the operating instructions carefully before attempting to operate the Model
206B.
Use eye protection at all times when operating the Model 206B.
Select the recommended jaw blocks and/or ramp set for the pipe size to be ma-
chined. (Refer to the jaw block selection chart.)
Install the mandrel assembly into the pipe.
In order to avoid cutting the jaw blocks during the machining operation, the
mandrel must be installed beyond the final end preparation location.
Tighten the draw nut to force the jaw blocks out to the inside diameter of the pipe or
tube.
Select the tool bit(s) required to machine the pipe to the configuration desired.
Use of dull or improperly designed tool bits or tool bits not manufactured by
TRI TOOL INC. may result in poor performance and may constitute abuse of
this machine and therefore voids the TRI TOOL INC. factory warranty.
When performing any multiple machining operation such as facing, beveling, and/or
counterboring, the counterbore tool bit should be installed to ‘lead’ the bevel tool bit.