Tri Tool 206B Beveler - Manual (Page 20)

20
TRI TOOL INC.
92-0211 : Rev. 050224
NOTE:
Tighten the set screws to secure the tool bit(s) to the tool holder(s).
Adjust the counterbore tool bit radially to control counterbore diameter.
Adjust the bevel tool bit radially to control the counterbore depth to the bevel rela-
tionship.
Slide the Model 206B gently onto the mandrel assembly until it comes to a solid stop
against the torque acceptance keys.
The Model 206B with the mandrel assembly installed maybe mounted to the pipe as
one unit.
Rotate the Model 206B as required to engage the torque acceptance keys with the
slots in the mandrel shaft.
Since the mandrel shaft will contact the torque acceptance keys before the
feed nut engages the mandrel shaft threads, caution should be taken not to
force (or allow) the machine to impact the lead threads of the feed nut with
the lead threads of the Mandrel.
ADJUSTMENT OF THE TORQUE ACCEPTANCE KEYS
Adjustment of the torque acceptance keys will be required if the BEVELMASTER™
is loose radially on the mandrel shaft.
This may appear as chatter in the tool bit.
Loosen the cap screws in both torque acceptance keys.
Rotate the set screw as required until the torque acceptance keys are riding snugly
in the slots in the mandrel shaft.