Thinklogical MX48 Router Manual - Manual (Page 22)

®
M X 4 8 R o u t e r P r o d u c t M a n u a l , R e v . F , D e c . 2 0 1 4 Page 18
5.4 How to Replace a Power Supply
Warning! Disconnect the power cord before proceeding!
Note: If ONE power supply is installed: shutdown IS required.
If TWO power supplies are installed, shutdown IS NOT required.
The Power Modules are universal input 120-240VAC 50-60Hz. Use the proper power cord for your
region (supplied with the unit). Although the router functions properly with one Power Module, it is
recommended that both Modules preferably be connected to two independent power sources (for
redundancy).
Step 1
Grasp the black handle with one hand.
Step 2
Slide the green tab to the left with the other hand.
Step 3
Pull the Power Module out of the chassis.
Step 4
Insert the new Power Module into the chassis and slide it in until it reaches the backplane connector.
The module should slide freely until it reaches the backplane connector. At this point, use just
enough force to firmly engage the card with the mating connector.
Warning! If the module does not slide into the connector, do not force it! Damage may
occur. Remove the module and start over.
6 Regulatory & Safety Compliance
Note: The following Safety and Compliance Declarations are pending approval.
6.1 Safety Requirements
Symbols found on the product
Markings and labels on the product follow industry-standard conventions. Regulatory markings found on
the products comply with domestic and many international requirements.
Regulatory Compliance
Thinklogical
®
’s MX48 is designed and made in the U.S.A. MX48 has been tested by a certified testing
laboratory and found to be compliant with the following standards (both domestic USA and many
international locations):
North America
Safety
ANSI/UL60950-1: 1 st Edition (2003)
CAN/CSA C22.2 No. 60950-1-03
LASER Safety
CDRH 21CFR 1040.10
Class 1 LASER Product