Teo 8810 ISDN Phone Installation - Manual (Page 35)

Installation Options
13-280118 Rev. C Page 35
ALERTING=ANY >
ANY NORMAL DIST INTCOM
ALERTING=ANY >
PRI
AUTOMATIC MUTE=ON
ON OFF
For example, 9995551
*
matches 999-555-1000 through 999-555-1999; 99955510#0 matches
999-555-1010, 999-555-1020, etc. Non-numeric characters (such as hyphens) in the incoming
caller ID are ignored. Up to 10 digits (including wild cards) may be programmed in each template.
Enter all digit positions as shown in the display for an incoming call; in most cases, this
will include the area code.
Press the Left Arrow key to enter additional Calling DN templates. The Right Arrow key moves
back to previously-entered templates.
When all Calling DN templates have been entered, press the OK key.
Selecting Alerting Patterns
Use the Alert option to allow only specific types of incoming calls (e.g. internal, external, intercom, etc.).
CA/DN keys must be configured for Voice Announce before selecting alerting patterns.
Select ALERT to define a specific alerting pattern required to validate incoming Voice Announce
calls.
ANY – Accept any type of alerting (default value)
NORMAL – normal alerting (pattern 0); typically used for internal calls.
DIST
– distinctive alerting-intergroup (pattern 1); typically used for external calls
INTCOM – EKTS intercom (pattern 3); used for intercom calls
PRI
– distinctive alerting-special/priority (pattern 2); used for designated priority calls
Press the OK key after selecting the alerting pattern.
Automatic Muting
Select MUTE.
Select ON to automatically mute the microphone during a Voice Announce call, or OFF to enable
two-way conversations.
Press the OK key after selecting the muting option.