Teo 8810 ISDN Phone Installation - Manual (Page 28)

Tone Commander 8810 Installation Instructions
Page 28 13-280118 Rev. C
VOICE MAIL ACCESS
NUMBER EDIT SWAP TYPE
95551432
5551234
Unused Keys
Any Speed Dial key can be changed to an Unused key by clearing the dialing string.
Any Unused key can be changed to a Speed Dial key by adding a dialing string – see page 26.
Select CLEAR to remove the dialing string. The key is converted to an Unused key.
Press the OK key to return to the key selection menu.
Voice Mail Keys
Voice Mail Access Key
Note: The VMAIL key must be programmed to dial the voice mail access number in order for this
feature to work properly. “Smart” pauses and PIN codes can be included in the number.
From the Installation Options menu, select KEYS.
(
SETUP → INSTL → KEYS)
Press the VMAIL key.
The Message Waiting indicator will flash.
Select NUMBER to view or change the VMAIL key speed dial number. This is the number that is
dialed to access your voice mail system.
The currently programmed dial string, if any, will be shown in the display.
Enter digits (24 maximum) with the dial pad.
“Smart” pauses are entered with the PAUSE softkey, and are shown in the display as a P
character. The first pause in a dial string will wait until the call is answered; additional pauses
delay dialing for one second. Enter multiple pauses to increase the delay time.
If you need to make corrections while entering numbers, select ◄BKSP (backspace) to delete the
previous digit. CLEAR removes all digits, allowing you to start over.
When all digits have been entered, press the OK key.