Teletronics EZStation5 - Manual (Page 42)

Page 42
This table describes the parameters that can be modified in DHCP
Server Setup.
Parameters Description
The fields DHCP Start IP Address and DHCP End IP Address fields allow you
to define the range of IP addresses from which the DHCP Server can
assign an IP address to the LAN.
DHCP Start IP Address
This is the first IP address that the DHCP server
will assign and should belong to the same
subnet as the access point. For example if the
access point IP address is 192.168.168.1 and
the network mask is 192.168.168.1 and
255.255.255.0, the DHCP Start IP Address should
be 192.168.168.X, where X can be any number
from 2 to 254. It is pre-set to 192.168.168.100.
DHCP End IP Address
This is the last IP address that the DHCP server
can assign and should also belong to the same
subnet as your access point. For example if the
access point IP address is 192.168.168.1 and
the network mask is 192.168.168.1 and
255.255.255.0, the DHCP End IP Address should
be 192.168.168.X, where X can be any number
from 2 to 254. It is pre-set as 192.168.168.254.