Teletronics EZStation5 - Manual (Page 112)

Page 112
Enable Parallel Broadband
Begin by verifying that every access point in the network is properly
configured to connect to its individual broadband Internet account.
Secondly ensure that either:
• each access point is connected to an Ethernet port in the network
OR
• the access points are wired to each other.
Then all the access points have to have the DHCP server, followed by
the Parallel Broadband feature, enabled through the web-based
configuration. Please note that all the access points need to be
interconnected.
Step 1:
Select Parallel Broadband from the CONFIGURATION command
menu.
Step 2:
Select Enable and click the Apply
button.
Step 3:
Repeat Step 1 and Step 2 for the
rest of the access points.
New users will then be assigned to
the access point with the smallest
load, ensuring that each access
point has approximately the same
number of users.
Important:
Implementing Parallel Broadband is redundant if there is
only 1 access point.