Teac CD-RW750 - Manual (Page 24)

4 – Recording
24
TASCAM CD-RW750 Owner’s Manual
To set the fade times:
1 Press the MENU key (
9
or
6
) repeatedly
until the display shows Fade IN > XXS ,
where XX is the current fade-in time, in
seconds.
2 Turn the MULTI JOG control B or use the
SKIP keys I to change the value of the fade-in
time.
3 Press the MENU key again so that the display
shows Fade OUT> XXS , where XX is the
current fade-out time, in seconds.
4 Turn the MULTI JOG control or use the SKIP
keys to change the value of the fade-out time.
It is possible to set the fade-in time only (per-
form step
5 after step 2 ) or the fade-out time
only (in step 1 , press the MENU key until the
fade-out time menu item is shown).
To perform a fade-in:
1 With a recordable disc loaded, press the
RECORD key ( K or E ) so that the unit enters
record ready mode.
2 Start the source material, and press the
FADER key (
M
or
B
).
The display shows Fade IN for the time
specified in the menu item above.
As the fade progresses, the monitored signal
gradually becomes louder, reflecting the level
recorded on disc.
To perform a fade-out:
1 While recording, press the FADER key (
M
or
B ).
The display shows Fade OUT for the time
specified in the menu above.
As the fade progresses, the monitored signal
gradually becomes quieter, reflecting the level
recorded on disc.
2 When the end of the fade-out time is reached,
the unit goes into record ready mode. Record-
ing can be restarted with the
FADER key or
the PLAY or PAUSE keys.
The fade-in and fade-out times can be reset to new
values while recording is in progress.
Fades are also possible in digital direct mode (“Digi-
tal direct” on page 23).