Teac CD-RW750 - Manual (Page 14)

2 – Features of the CD-RW750
14
TASCAM CD-RW750 Owner’s Manual
Use of the remote control unit
When using the RC-RW750 remote control unit,
make sure:
• There is a clear unobstructed path between the
remote control unit and the remote sensor
7
on the
main unit.
• The remote control unit is located within 5 m
(15 ft.) of the main unit, and is pointing at approxi-
mately right angles (±30°) to the front panel.
When fitting or replacing the batteries:
• Always make sure that both batteries are replaced
together. Do not mix old and new batteries.
• Do not mix batteries of different types.
• Always make sure that the batteries are located
with the correct polarity (the positive terminals of
the batteries should match the
+ markings inside
the battery compartment, and the negative termi-
nals should match the
– markings).
• If you are not going to use the remote control unit
for an extended period of time, remove the batter-
ies. Old batteries can leak, casing damage to the
remote control unit.
• Always dispose of old batteries in the way recom-
mended by your local garbage disposal authorities.
Connections
The following should be noted when you connect the
unit to other equipment.
It is possible to connect the unit’s DIGITAL
COAXIAL IN
P and DIGITAL OPTICAL IN
Q to
other equipment at the same time. However, the unit
can receive signals from only one digital input at a
time.
Audio signals output from the unit are output from
the analog
ANALOG OUT
O jacks, as well as from
the DIGITAL COAXIAL OUT jack
P
and DIGITAL
OPTICAL OUT connector Q simultaneously (but not
from the digital outputs in stop mode).
Using the timer function
You can set the CD-RW750 to start playback when it
is switched on (for example, from an external timer).
To do this, slide the
TIMER switch C to the PLAY
position.
When the unit is turned on it will start playing from
the start of the loaded disc.