Teac CD-RW750 - Manual (Page 17)

3 – Playback operations
TASCAM CD-RW750 Owner’s Manual
17
Programmed order playback
The steps to set up to 32 program steps (tracks) to be
played back in a specified order are as follows:
1 Press the PLAY MODE key A until the display
shows Program .
2 The display changes to show
0 Tr 0:00 00 ,
meaning that no program steps have yet had
tracks assigned to them.
3 Use the number keys to enter a track number
(including the
+10 key to enter values greater
than 9, as described in “Track search” on
page 16). There is no need to press
ENTER .
The track entered is assigned to the program
step, and the display changes, showing the
track number, the total time of the program so
far, and the step number, e.g.
2 Tr 14:56 03 .
4 The next program step can then be entered.
NOTE
Steps 3 and 4 above can be carried out from the main
unit by turning and pushing the
MULTI JOG control
B .
5 Repeat steps 3 and 4 above until the program
is complete.
6 Press the PLAY key (
I
or
L
) to start play-
back at the first program step.
The display shows the track, the current time
display, and the program step number.
While in programmed playback mode, using
the
SKIP keys
I
or the MULTI JOG control
B
moves backwards and forwards in the order
set in the program.
Use the PAUSE key ( J or K ) to halt playback tem-
porarily or the STOP key ( H or J ) to stop playback
of the program.
If the STOP key is used, when playback is restarted,
it starts from the first program step.
Clear the program by pressing PLAY MODE
A until
the display shows Continue . The program is
also cleared when the disc tray is opened, and if the
STOP key is pressed when playback is stopped in
programmed order mode.
The programmed play order is not memorized when
power is turned off.
If an attempt is made to enter more than 32 program
steps, the message
PGM Full ! appears on the
display.
Repeat play
The unit can repeat the whole of the disc (or pro-
gram) or the current track only or A-B repeat
between two points.
The unit should be in playback, pause or stop mode.
1 With the unit in playback, pause or stop mode,
continue to press the
REPEAT key (
4
or
4
)
so that the display shows REPEAT 1 (the
REPEAT 1 indicator lights) to repeat one track,
or REPEAT All (the REPEAT ALL indicator
lights) to repeat the whole disc or program.
2 If playback has not started, restart it.
To cancel repeat mode, press the REPEAT key so that
the display shows REPEAT Off and the REPEAT
indicator goes out.
A-B repeat mode
This mode allows looped playback between two
points.
NOTE
Selecting the A-B repeat mode is only possible using the
remote control unit.
1 With the disc playing back, press the A-B key
5 at the point where the loop is to start. The
REPEAT indicator lights and the A-B indicator
flashes.
2 Press the A-B key again at the point where the
loop will end. The A-B indicator lights in the
display.
To cancel the A-B repeat mode:
1 Either press the STOP key, or press the A-B
once more.
If you press the STOP key, playback stops, and
if you press the A-B key, playback continues to
the B (end) point of the loop and continues
from there.