Teac 2488 Reference Manual - Manual (Page 25)

5 – Error and status messages
TASCAM 2488 Reference Manual
25
33
Too many takes.
Can’t continue
recording
Press [EXIT].
The repeat auto-punch procedure can’t
continue because more than 99 takes have
been recorded. Press EXIT , stop recording, select the
desired take from the list. Press ENTER and
press AUTO PUNCH again, selecting a
mode other than LAST TAKE LOAD . Takes
recorded before this cannot be restored, so
the first selection should be made carefully!
34
Track already
written to disc
so only 1 song
can be written.
Press [EXIT].
Because at least one track is already present
on the disc, it is not possible to burn more
than one track at once. To burn several tracks
at one time (Disc At Once), you must start
with a blank disc. Press EXIT and replace the disc if necessary.
35
Track is too
short. Choose
and set another
OUT point.
Press [EXIT].
The distance between the zero point and the
OUT point is too short for mastering. A CD
track must be at least four seconds long. Press EXIT , and re-set the OUT point to at
least four seconds after the zero point.
36
Wrong type of
CD. Check the
disc.
Press [EXIT].
The wrong type of CD for the operation has
been loaded in the drive. This could be
because :
A non-writable CD has been selected for
writing
An attempt has been made to finalize an
already finalized disc
An attempt has been made to erase a non-
CD-RW disc.
A disc which is not a backup disc has been
loaded for a restore operation. Press EXIT and replace the disc with the
correct type of disc for the operation.
No. Message Meaning Action