Teac 2488 Reference Manual - Manual (Page 10)

1 – MIDI Control/Program Change messages
10
TASCAM 2488 Reference Manual
MIDI Program Change messages
The 2488 can accept Program Change messages to
select an effect and to change scenes.
Before a Program Change message is sent for chang-
ing an effect, a Bank Select message must be sent to
select whether an effect will be selected from the pre-
set bank or from the user bank of memories. In each
case, bank 0 corresponds to the preset memories, and
bank 1 to the user bank.
Send the Bank Select messages (CC 0) on MIDI
channels 1 through 8 for mic effects (see below),
MIDI channel 9 for stereo dynamics, channel 10 for
the single effect, and channel 11 for the multi effect.
When selecting a mic effect, a Bank Select message
should first be sent on channel 14 to select the group
of eight channels or inputs out of which the channel
is selected:
Bank 0: Mixer channels 1 though 8
Bank 1: Mixer channels 9 through 16
Bank 2: Mixer channels 17 through 24
Bank 3: Inputs A through H
The Program Change messages that are then valid are
as follows (see the tables following for details of the
preset values—the “user” messages correspond to the
entry number in the library):
Mic effects (preset) Program Change 0 to 2
Mic effects (user) Program Change 0 to 99
(maximum)
Stereo dynamics effect (preset) Program
Change 0 to 1
Stereo dynamics effect (user) Program
Change 0 to 99 (maximum)
Single effect (preset) Program Change 0 to 34
Single effect (user) Program Change 0 to 99
(maximum)
Multi effect (preset) Program Change 0 to 41
Multi effect (user) Program Change 0 to 99
(maximum)
Scene memory Program Change messages
These are transmitted on channel 16. The Program
Change message may be from 0 to 99.
4 Wah (WAH)
00 15 Attack 0 – 100 = 0 – 100
00 16 Sense 0 – 100 = 0 – 100
00 17 Pedal 0, 1 = Off, On
00 18 (reserved)
00 19 Switch 0, 1 = Off, On
5 Delay (DLY)
00 20 Delay Time 0 – 1000 = 0 – 1000(ms)
00 21 Feedback 0 – 100 = 0 – 100
00 22 Hi Damp 0 – 100 = 0 – 100
00 23 Mix Level 0 – 100 = 0 – 100
00 24 Switch 0, 1 = Off, On
Effect
chain #
Effect NRPN Parameter Values