Teac 2488 Reference Manual - Manual (Page 22)

5 – Error and status messages
22
TASCAM 2488 Reference Manual
9
File too big to
export. Choose
another file
for export.
Press [EXIT].
The data selected for export to the FAT
partition is too big (there is not sufficient
space on the FAT partition). Press EXIT , use the USB OPEN function to
manage the files (move or delete unwanted
ones) on the FAT partition from a computer
and retry. Alternatively, if there is no wanted
data on the FAT partition, use the 2488 to
reformat the FAT partition (all data on the
FAT partition is irrecoverably lost). The FAT
partition size is fixed at 4 GB.
10
Import file not
found. Use
USB OPEN to
import file.
Press [EXIT].
The file selected (backup file, WAV file for
import, or SMF) is not available. Press EXIT , use the USB OPEN function to
transfer the appropriate file to the FAT
partition and then try importing again.
11
Invalid Fs rate
detected. Check
your system
set-up
Press [EXIT].
Digital audio input mode has been selected,
but the 2488 has detected the wrong
sampling frequency (Fs) for the incoming
digital audio to be used. Press EXIT and check the digital audio
source. The output should be 44.1kHz (note
that some players output 48kHz). A unit with
varispeed (pitch control) may have varispeed
turned on, altering the sampling frequency
from 44.1kHz.
12
Master track is
too short. Use
PRE-MASTERING
to correct it.
Press [EXIT].
The master track is too short, and therefore
cannot be checked. Press EXIT , re-set the OUT point to at least
four seconds after the zero point, then use
the
PRE-MASTERING menu item for checking.
13
MTC slave mode
selected.
Cannot do this
operation now.
Press [EXIT].
Since the unit is currently slaved to external
MIDI timecode, the selected operation
cannot take place. Operations not possible in
MTC slave mode include: pitch control and
SSA, repeat playback, auto-punch operations,
jog and trim as well as audio CD playback
and digital audio input. Press EXIT and use the menu system
( SYNC/MIDI->SYNC ) to select INTERNAL sync.
14
No file for import
has been found.
Change CD [YES],
else press [NO] No WAV file for import has been discovered
on the loaded CD. Press YES to change the disc (use an
ISO9660 formatted disc which contains audio
data with 44.1kHz sampling frequency in
WAV format) or
NO to cancel the operation.
15
No free hard
disk space, Use
DELETE UNUSED
to make space.
Press [EXIT].
The hard disk is full, and the current
operation has failed because it needs hard
disk space. Press EXIT and use one of the SONG menu
operations such as DELETE UNUSED or ERASE
to free up some space (these operations
cannot be undone).
16
No LAST REC
point. Use
IN-OUT instead.
Press [EXIT].
Can’t use the last recording point for auto-
punch operations, as no recording has been
done yet. Press EXIT and set the IN and OUT points as
the punch positions. Use the RHSL key to
refine these points if necessary, by rehearsing
takes without recording.
No. Message Meaning Action