Teac DR-07MKII - Manual (Page 67)

TASCAM DR-07MKII
67
7 Use the + or - button to select the level that
signal is judged to have been input when it
exceeds this level.
Set the value to one of the following
selection.
-6dB
/
-12dB
(default)/
-24dB
/
-48dB
8 Press the (HOME)[ª] button to return
to the Home Screen.
9 Press the RECORD [º] button to put the
unit into recording standby.
Recording starts automatically when the
input signal exceeds the
LEVEL
.
10 The recording mode changes according to
the setting of the
MODE
.
REC
:
If the input signal level falls below the
standard level for more than five seconds,
which is set on
LEVEL
, the unit goes into in
recording standby. When the input signal
level becomes higher than the standard level,
the unit restarts recording on a new file.
MARK
:
If the input signal level falls below the
standard level for more than five seconds,
which is set on
LEVEL
, the unit adds marks
when the input signal level becomes higher
than the standard level again.
11 Press the (HOME)[ª] button to stop
automatic recording.
4–Recording