Super Systems SuperDATA Load Entry - Manual (Page 42)

SuperDATA Standard Load Entry Operations Manual
Super Systems Inc. Page 42 of 58
Appendix 2: Example of an Initial Setup
IMPORTANT!
There are many ways in which to configure Load Entry for initial use; the example is a
procedure that can be used for many initial setups, depending on your facility’s requirements.
Call SSi at (513) 772-0060 with questions.
The following procedure is an example procedure for initial setup. Please note that there are
many ways in which to configure Load Entry for initial use; the example is a procedure that can
be used for many initial setups, depending on your facility’s requirements. Also note that the
functions used during initial setup will typically need to be used again—for example, to add new
users, adjust furnace parameters, etc. If you have questions, call SSi at (513) 772-0060.
Install Standard Load Entry
In this example, we will install Standard Load Entry using a new database installed on the local
computer. In addition, we will install Standard Load Entry as a Server (default) and not as a
Workstation.
Prerequisites will be installed automatically during the installation process.
To begin the installation, run the file
SSiLoadEntry_Setup.exe. A screen
similar to the one at right will be shown.
Click Install to begin the installation
procedure.
A series of screens will appear allowing
you to confirm installation, change the
default installation folder, and install
Standard Load Entry as a server or as a
workstation. SSi recommends using the
default installation folder,
“C:\SSi\Bin\SSi Load Entry System\”.
For the installation type, select
“Server”. Click Next in each case to
proceed.