Sundance SMT6040 - Manual (Page 49)

Sundance Multiprocessor Technology Limited
Form : QCF32
SMT6040
“Sundance Simulink Toolbox” Date : 6 July 2006
Comport connections required by this demo can be implemented on a SMT310Q carrier
board. As the SMT148-FX stand-alone carrier implements comports via firmware,
SMT148-FX users should match comport connections used in the demo with the ones
implemented by their firmware.
Please notice also that users with Diamond DSP single processor license need to modify the
SMT362 demos (by moving the design onto one SMT362 DSP only) to be able to run it. For
this reason, University customers with a Diamond 1xDSP license are recommended to use
SDR demo 3 (paragraph 3.1) as starting point for their developments.
We now focus in particular on the “ test_SMT368_SMT362.mdl” demo, but it is easy to verify that
these explanations apply to the other demos too, apart from the different processor types,
which can be configured from a scroll-down menu.
Figure 43: SDR demo SMT6040 diagram
The demo described in the paragraph 1.2 targets the SMT362+SMT351T+SMT350 system
and is therefore very similar.
Figure 43 represents the SMT6040 Simulink diagram “test_SMT368_SMT362.mdl” (top
left) and the three Simulink subsystems (one per each processor). The full system also depicts
the connections between the processors, the input sine-wave blocks and the scopes that are
used during simulation to verify the behaviour of the system.
SMT6040 - “Sundance Simulink Toolbox” Last Edited: 08/01/2010 15.42 Page 49 of 53