Sundance SMT6040 - Manual (Page 43)

Sundance Multiprocessor Technology Limited
Form : QCF32
SMT6040
“Sundance Simulink Toolbox” Date : 6 July 2006
Figure 36: DSP hardware interface
Other blocks generate two sequences of data:
• A Ramp on Diamond output channel 0 (write), which goes to node node1, as described
in the top diagram.
• A Sine on Diamond output channel 1 (write), which goes to node node1, as described in
the top diagram.
The remaining blocks receive data from:
• Diamond input channel 0 (read), which comes from the FPGA module, as described in
the top diagram; data is a 2-dimensional vector formatted as shown in the Input Digital
HW Parameters dialog box of the sim_Diamond_channel block. Configuration can be
changed as shown in Figure 37.
• Diamond input channel 1 (read), which comes from node node1, as described in the top
diagram, process them and occasionally printf to the console.
SMT6040 - “Sundance Simulink Toolbox” Last Edited: 08/01/2010 15.42 Page 43 of 53