Sundance SMT6040 - Manual (Page 38)

Sundance Multiprocessor Technology Limited
Form : QCF32
SMT6040
“Sundance Simulink Toolbox” Date : 6 July 2006
SMT8036E_SDRDemo: it includes a “SimulinkProject” that creates a DSP task from a
SMT6040 diagram and a Diamond project that uses this task. More details in this regard in
Chapters 3 and 4.
This demo is recommended as starting point for all users of the SMT8036E SDR Special
University Offer.
Version2\SMT8096_noSysGen: this folder includes obsolete demos targeting systems
composed by SMT395 or SMT362 as DSP board and by SMT368 or SMT351T as FPGA board,
plus the SMT350 as DAQ module. These demos are not supported but they can be utilized by
advanced users for their custom developments. These demos fully demonstrate the
functionality of the hardware: processing on the DSP and data acquisition from ADC/DAC
board through the FPGA. These demos target a number of Sundance SDR systems as
highlighted in the table below. For more accurate descriptions, please read Chapter 4.
Please notice that these demos are designed for a PCI carrier (SMT310Q). Users of stand-
alone carriers (e.g. SMT148-FX) can easily modify these demos (in particular comport
connections) to adapt them to their needs.
Demo System
SMT8096_ADC_DSP_DAC.mdl SMT8096 (SMT395+SMT368+SMT350)
SMT8096_DSP_only.mdl SMT8096 (SMT395+SMT368+SMT350)
test_SMT368_SMT362.mdl SMT362+SMT368+SMT350
test_SMT351TSX95_SMT395VP30.mdl SMT395+SMT351TSX95+SMT350
test_SMT351TSX50_SMT395VP30.mdl SMT395+SMT351TSX50+SMT350
test_SMT351TSX95_SMT362.mdl SMT362+SMT351TSX95+SMT350
test_SMT351TSX50_SMT362.mdl SMT362+SMT351TSX50+SMT350
test_SMT395: this folder contains a test demo for the SMT395 DSP.
Version2_OLD\test_SMT368: this folder contains a demo that tests the SMT368 leds
(“testLeds.mdl”) and a demo that can be used as an example design for the
SMT368+SMT350 combination.
test_SMT362: these demos demonstrate the behaviour of the SMT362 DSP board when
using only one or both DSPs.
Version2_OLD\test_SMT351T: here are a demo to test the SMT351T alone
(“testLeds.mdl”) and two demos to be used as examples for the SMT351T+SMT350
combination.
Version2_OLD\test_SMT350: this folder contains a number of designs that target the
SMT350 board (they should be utilised by advanced users).
Version2_OLD\SDR_SMT8036E: This folder is divided in a number of subfolders, each
containing demos targeting the whole system or the single boards that compose the
SDR_SMT8036E kit (SMT365E and SMT370. The SMT365 was featured in the SMT8036
and has now been replaced by the SMT365E, so its demos are not relevant for new users).
SMT6040 - “Sundance Simulink Toolbox” Last Edited: 08/01/2010 15.42 Page 38 of 53