Sloan ETF-600 Faucet - Manual (Page 2)

2
FAUCET ROUGH-IN
1A - INSTALL ETF-600 FAUCET
ETF-600 Faucet with Bak-Chek ® Tee
for Hot and Cold Water Supply †
ETF-610 Faucet with Bak-Chek ® Tee for Hot and
Cold Water Supply (shown with 4” trim plate) ‡
ETF-610 Faucet with BDM and BDT Variation Mixing
Valves for Hot and Cold Water Supply
(shown with 4” trim plate) ‡
ETF-610 Faucet with ADM Variation Mixing Valve for
Hot & Cold Water Supply (shown with 8” trim plate) ‡
FAUCET
MOUNTING
STUDS
1/8” NPT PIPE
NIPPLE
SLOTTED
MOUNTING
WASHERS (2)
WING NUTS (2)
SENSOR
CABLE
BASE GASKET
Note: Refer to the Installation Instructions included with the
ETF-578-A Trim Plate for additional information about using an
8" Trim Plate with an ETF-600 faucet.
Apply thread sealant or Teflon tape to threads at end of Faucet
Pipe Nipple. Install 1/8" Pipe x 3/8” Tube Compression Fitting on
end of Faucet Pipe Nipple. D
A Slide Base Gasket onto
Faucet.
Insert Faucet Sensor
Cable, Pipe Nipple, and
Mounting Studs through
the 4” (102 mm) spread
deck holes. B
Secure Faucet to deck using Slotted Mounting Washers and Wing
Nuts supplied. C
ETF-600 Faucet
ETF-610 Faucet
1/8” NPT PIPE TO 3/8” TUBE
COMPRESSION FITTING
ETF-600 Faucet with BDM and BDT Variation
Mixing Valves for Hot and Cold Water Supply †