Sloan EBF-187 Faucet - Manual (Page 2)

2
1A ETF-295-A (for EBF-85) Single Hole 4” Trim Plate
A
Slide Rubber Faucet Gasket onto Faucet Shank. Ensure that Roll
Pin on base of Faucet fits into hole in Rubber Faucet Gasket.
FAUCET ROUGH-IN
Note: When installing with a Sloan Mixing Valve, install Faucet and Trim
Plate before installing Mixing Valve. For complete installation guidelines,
refer to the Installation Instructions supplied with the Sloan mixing valve.
B
Insert Hex Bolts into Black Plastic Base Plate (if sink has only a
center hole, see note above). Place Chrome Cover Plate over
Black Plastic Base Plate. Slide Trim Plate assembly onto Faucet
Shank. Align Roll Pin with small hole in Trim Plate assembly.
Note: If Trim Plate is used on a sink with a center hole only, Trim Plate
Bolts are not used. Apply plumber’s putty to underside of Trim Plate to
prevent Faucet from rotating.
C
Insert Trim Plate Bolts through the 4 inch (102 mm) spread deck
holes and Faucet Shank through the 1 inch (25 mm) minimum
diameter deck hole. Secure Trim Plate to Deck using the large
Plate Washers and Hex Nuts supplied. Secure Faucet from below
Deck using the Flange Nut supplied.
ROLL PIN
RUBBER
FAUCET GASKET
COVER PLATE
BLACK PLASTIC
BASE PLATE
DECK
FAUCET SHANK
TRIM PLATE
HEX BOLTS (2)
PLATE
WASHERS (2)
HEX NUTS (2)
FLANGE NUT
1 Install Faucet Spout and Trim
Plate — Refer to the appropriate
step (1A-1C) for your application.
EBF-85 and EBF-187 Faucet with Bak-Chek ® Tee
for Hot and Cold Water Supply
(shown with 4” trim plate)
EBF-85 and EBF-187 Faucet with ADM Variation
Mixing Valve for Hot and Cold Water Supply
(shown with 8” trim plate)
EBF-85 and EBF-187 Faucet with BDM and BDT
Variation Mixing Valves for Hot and Cold Water
Supply (shown with 4” trim plate)
EBF-85 and EBF-187 Battery Powered Faucet
EBF-85 FAUCET
FAUCET INSTALLATION