beautypg.com

E d i t, S a v e – Seaward Sentinel User Manual

Page 17

background image


ELECTRICAL SAFETY TESTER

USER MANUAL



27

Stop on fail

Stop on fail at the DUT detection.

Stop on pass

Stop on pass at the DUT detection.

IR TEST MODE

Timer

Reach the time of determination for
pass or fail.

ZERO CHECK
(GB only)

Zero check by shorting the resistance of test leads
only for ground bond test.

RS-232 Baud
Rate

1200, 2400, 4800, 9600.

Interface

GPIB
Address

00~31

Stop

The operation will stop upon the failure
occurred at any step of group test.

FAIL Setting

Continue

The operation will not stop until all 16
group steps has been tested.


z To Edit/Save the System Utility

1. Follow the above procedure “To View the System Utility” to select

a parameter.

2. Press the EDIT/SAVE key to enter status EDIT.

EDIT/SAVE

E D I T


ELECTRICAL SAFETY TESTER

USER MANUAL



28

3. Use knob to adjust parameter. Use arrow keys to change knob’s

resolution.

4. After setting this parameter, press EDIT/SAVE key to save the

parameter. The status will become SAVE. After the parameter is

saved, the status will return to EDIT.

5. Repeat the procedure “To View the System Utility” to select another

parameter.

T E S T M O D E
F R O M S T E P

EDIT/SAVE

S A V E