Seaward Europa Pac Plus User Manual

Page 21

Storing Test Results

The first time the STORE RESULT button is pressed after switch on
after performing a test the user will be prompted to enter the date.

The primary display will flash dAt for approximately 2s then display
the currently set day / month e.g. 12.07 for 12 July. The secondary
display will show the currently set year. The leading day digit will be
flashing, indicating that it can be changed. Use the cursor buttons to
change the value. Press the SELECT button to allow the second day
digit to be changed, indicated by the digit flashing. Use the cursor
buttons to change its value. Press the SELECT button to allow the
month to be changed. Proceed to change the month in the same way
as the day. After the month is changed, the year can be changed in
the same manner.

At any time (when the entire date is correct) pressing the STORE
RESULT button will cause the tester to check the date is valid and if
correct will store it to memory. Invalid dates will not be stored.

All subsequent result stores will not ask for the date until the tester is
reset.

Press STORE RESULT to store the displayed date.

At any time during the date entry, pressing the CHANGE DISPLAY
button or rotary switch action cancel any changes and leave the date
unchanged in memory.

Appliance Number and Storing Results

After the date has been stored or has been set on a previous store,
pressing the STORE RESULTS button will cause the primary display
to flash STOR for about 2s then both primary and secondary displays
will display four digits each (eight total) with the lead digit flashing.
Use the cursor buttons to change the value of the digit. Pressing the
SELECT button will cause the next digit in turn to flash indicating that
its value can be changed using the cursor buttons. Use the SELECT
button to select each digit in turn changing the value if appropriate
with the cursor buttons until the correct appliance number is
displayed.

Press the STORE RESULT button to store the displayed appliance
number. The tester will display STOR on the primary display with the
secondary display alternating between ‘----‘ and a memory location
for approximately 2s. Confirmation that the result has been stored is
signaled by two short beeps.