Seaward Europa Pac Plus - Manual (Page 19)

Set-Up Data
13
ton3 – Beep when mains voltage applied to test socket
ton4 – Beep if test limit exceeded
To set the selected option to off or on press the SELECT button. Now
the option’s setting will flash, use the cursor buttons to chose the
preferred setting, then press the STORE RESULT to go back to the
options. At any time you can switch the rotary knob to a different
selection and the current beep options will be active.
Substitute Leakage Setting
The Substitute Leakage can be set to display the reading for different
set level increases in mains voltage. These are:
230v = 0%
244v = 6%
253v = 10%
With the primary display flashing cycle through the settings until
SubS is displayed using the cursor buttons.
To set the selected option, press the SELECT button. Now the
option’s setting will flash, use the cursor buttons to chose the
preferred setting, then press the STORE RESULT to go back to the
options. At any time you can switch the rotary knob to a different
selection and the current option will be active.
Leakage Test Setting
If a Leakage test exceeds the display range, the test can be stopped
or allowed to carry on.
With the primary display flashing cycle through the settings until SEt1
is displayed using the cursor buttons.
To set this option to off or on press the SELECT button. Now the
option’s setting will flash, use the cursor buttons to chose the
preferred setting, then press the STORE RESULT to go back to the
options. At any time you can switch the rotary knob to a different
selection and the current options will be active.