Scotsman NME654R - Manual (Page 34)

To Remove and Repair the Gearmotor
Assembly:
(Assuming that the procedures through removal of
the water seal have been performed.)
1. Remove the electrical wires from the gear drive
motor.
2. Unscrew the 4 cap screws holding the
gearmotor to the gearmotor plate.
3. Remove the gearmotor from the icemaker.
To Inspect the Gearmotor.
A) Remove the cap screws holding the gearmotor
case halves together and pry the two cases apart.
B) To lift off the cover, lift up until you can feel
internal contact, then pull the cover towards the
output gear end, and then lift the cover (with drive
motor attached) up and away from the gear motor
case.
Note: The case cover output gear, bearings, and
shaft are one pressed together assembly. Replace
as a unit.
C) Inspect the oil, gears, and bearings. If the oil
level and condition is acceptable, quickly check the
gears and bearings. They are likely to be fine if the
oil is.
If there is evidence of water in the oil (rusty
bearings and gears; the oil having a creamy white
appearance; oil level too high) carefully inspect the
bearings and gears. If in doubt about the condition
of a part, replace it. The oil quantity is 14 fluid
ounces, do not overfill.
Note: The gears and bearings are available only as
pressed together sets.
D) After replacing parts as required, (if any)
reassemble the gearcase. The two smaller gears
and the oil should be in the lower case, the output
gear will be with the cover. As the cover is lowered
onto the lower case, the cover will have to be
moved closer to the second gear after the output
gear has cleared the second gear top bearing.
E) After the case is together, and the locating pins
are secure in both ends, replace all cap screws.
4. Bench test the gearmotor, check for oil leaks,
noise, and amp draw.
NME654R & FME804R
January 2000
Page 34
OUTPUT GEAR,
OUTPUT SHAFT,
AND BEARINGS
GASKET
GEARCASE
DRIVE MOTOR
BEARING
WATER SHED
REMOVAL AND REPLACEMENT: Gearmotor Assembly