Scotsman FME24RLM - Manual (Page 26)

To Remove and Repair the Gearmotor
Assembly:
(Assuming that the procedures through removal of
the water seal have been performed.)
1. Remove the electrical wires from the gear drive
motor.
2. Unscrew the 4 cap screws holding the
gearmotor to the gearmotor plate.
3. Remove the gearmotor from the ice maker.
To Inspect the gearmotor.
A) Remove the cap screws holding the gearmotor
case halves together and pry the two cases apart.
B) To lift off the cover, lift up until you can feel
internal contact, then pull the cover towards the
output gear end, and then
lift the cover (with drive
motor attached) up and
away from the gear motor
case.
Note: The case cover
output gear, bearings, and
shaft are one pressed
together assembly.
Replace as a unit.
C) Inspect the oil, gears,
and bearings. If the oil level
and condition is
acceptable, quickly check
the gears and bearings.
They are likely to be fine if
the oil is.
If there is evidence of
water in the oil (rusty
bearings and gears; the oil
having a creamy white
appearance; oil level too
high) carefully inspect the
bearings and gears. If in
doubt about the condition
of a part, replace it. The oil
quantity is 14 fluid ounces,
do not overfill.
Note: The gears and
bearings are available only
as pressed together sets.
D) After replacing parts as required, (if any)
reassemble the gearcase. The two smaller gears
and the oil should be in the lower case, the output
gear will be with the cover. As you lower the cover
onto the lower case, cover will have to be moved
closer to the second gear after the output gear has
cleared the second gear top bearing.
E) After the case is together, and the locating pins
are secure in both ends, replace all cap screws.
4. Bench test the gearmotor, check for oil leaks,
noise, and amp draw.
Double System RL
November 2000
Page 26
SEAL
MOTOR
GEARCASE
COVER
BEARING
GASKET
REMOVAL AND REPLACEMENT: Gearmotor