The usb does't play video well, Confirm if there is signal output, Flash point in led display output – RGBLink CP 3072 User Manual User Manual

Page 61: Confirm if monitor output is normal, Choose hdmi signal as hdmi input, The usb doesn't play video well

CP 3072 User Manual 61

Confirm if There are Multiple Videos in USB Root Directory

Pull out the USB from CP 3072 and plug in to the computer, check if there

is video in USB root directory, do not save other non-video files at the same

time. User can also copy some video files to the USB after formatting it.

Confirm If There is Signal Output

If CP 3072 works well before, but the USB can’t play after restart, user can

pull and plug the USB for test under normal operation and UPS.

Confirm If Monitor Output is Normal

Find a belt VGA input (best for DVI) display, connect to the corresponding

output port of processor, and check whether the signal is correct on the

monitor. If display normally shows and no flash point, please check

whether DVI outlets put tight. If display flashes point, please judge if input

signal, wire, and interface are normal.

Choose HDMI Signal as HDMI Input

Choose HDMI signal as HDMI input. Push the [MENU] button, then choose

, turn the knob and choose , choose the

HDMI input and set the input source as HDMI. User need to restart the

blu-ray DVD.