2 call control and ppp/mp setup – Draytek 2900 User Manual
Page 61
Vigor2900 Series User’s Guide
55
3
3
.
.
2
2
C
C
a
a
l
l
l
l
C
C
o
o
n
n
t
t
r
r
o
o
l
l
a
a
n
n
d
d
P
P
P
P
P
P
/
/
M
M
P
P
S
S
e
e
t
t
u
u
p
p
Some applications require that the router (only for the i models) be remotely activated, or be
able to dial up to the ISP via the ISDN interface. Vigor routers provide this feature which
allows you to make a phone call to the router and then ask it to dial up to the ISP. Accordingly,
you can access your remote network to retrieve resources. Of course, you should have a fixed
IP address and expose some internal network resources to the outside world, such as FTP,
WWW and so on.
Note: Call Control and PPP/MP are only available for the models of Vigor2900VGi
and Vigor2900Vi equipped with the ISDN interface.
Click Call Control and PPP/MP Setup from Advanced Setup group.
Note: Please set Dialing to a Single ISP first before configuring this web page.
Dial Retry
It specifies the dial retry counts per triggered packet. A
triggered packet is the packet whose destination is outside the
local network. The default setting is no dial retry. If set to 5, for
each triggered packet, the router will dial 5 times until it is
connected to the ISP or remote access router.
Dial Delay Interval
It specifies the interval between dialup retries. By default, the
interval is 0 second.
Remote Activation
It specifies a phone number in the Remote Activation field to
enable the remote activation function. If the router accepts a call
from the number 12345678, it will terminate the incoming call
immediately and dial to the ISP.
Link Type
Because ISDN has two B channels (64Kbps/per channel), you
can specify whether you would like to have single B channel,
two B channels or BOD (Bandwidth on Demand). Four options
are available: Link Disable, Dialup 64Kbps, Dialup 128Kbps,
Dialup BOD.