6 management setup – Draytek 2900 User Manual
Page 136
Vigor2900 Series User’s Guide
130
4
4
.
.
6
6
M
M
a
a
n
n
a
a
g
g
e
e
m
m
e
e
n
n
t
t
S
S
e
e
t
t
u
u
p
p
The port number used to send/receive SIP message for building a session. The default value is
5060 and this must match with the peer Registrar when making VoIP calls.
Enable remote firmware
upgrade
Chick the checkbox to allow remote firmware upgrade through
FTP (File Transfer Protocol).
Allow management from the
Internet
Enable the checkbox to allow system administrators to login
from the Internet. By default, it is not allowed.
Disable PING from the Internet
Check the checkbox to reject all PING packets from the
Internet. For security issue, this function is enabled by default.
Access List
You could specify that the system administrator can only
login from a specific host or network defined in the list. A
maximum of three IPs/subnet masks is allowed.
List IP - Indicate an IP address allowed to login to the
router.
Subnet Mask - Represent a subnet mask allowed to login to
the router.
Default Ports
Check to use standard port numbers for the Telnet and
HTTP servers.
User Defined Ports
Check to specify user-defined port numbers for the Telnet
and HTTP servers.
Enable SNMP Agent
Check it to enable this function.
Get Community
Set the name for getting community by typing a proper
character. The default setting is public.
Set Community
Set community by typing a proper name. The default
setting is private.
Manager Host IP
Set one host as the manager to execute SNMP function.
Please type in IP address to specify certain host.