Rena T-750 - Manual (Page 9)

GETTING ACQUAINTED
Control Panel
1. *TRANSPORT POWER SWITCH – Turns the T-750 transport power ON.
2. SPEED CONTROL – Adjusts the speed of the T-750.
NOTE: The maximum speed of the T-750 tabber is determined by number of tabs being applied. The
speed of the tabber, for applying single tabs is 20,000 pieces per hour, for applying double tabs it is
12,000 pieces per hour and for applying triple tabs it is 8, 000 pieces per hour. Exceeding these speeds
will cause the tabber to stop.
3. LCD DISPLAY – Keeps the operator informed of the status of the T-750.
4. KEY PAD – Used to set the adjustments and program the T-750
5. EMERGENCY STOP – Pressing this button will stop the tabber (turns off transport
power) and will stop any devices connected to the Emergency Stop (Safety Stop) circuit.
Turn button clockwise to release (reset) it.
6. SOFT KEYS – The soft keys are used to step through the various menu options.
7. STOP KEY – Pressing this key will stop the T-750 and hold it in a ready state to
resume operation.
8. RUN KEY – Pressing this key to start the T-750.
9. INFO KEY – Provides additional information about the menu item you are viewing.
10. SAVE KEY – This key is used to save numeric keypad entries into memory.
11. CLEAR KEY – This key will clear any incorrect entry before it is saved into memory.
*Transport power will not activate unless all safety and emergency stop circuits are closed.
9