Rena T-750 - Manual (Page 41)

SETUP AND OPERATION
Applying a Single Stamp
When applying a single stamp to an envelope the
T-750 is setup the same as described for tabbing,
except for the following:
ƒ You must move the Tab Applicator Head
from the Tab position [A] to the Stamp
position {B}.
This can be done by pressing the locking
lever [2] while sliding the Applicator Head
to the desired position.
ƒ Select # Tabs as 1.
Select option to edit, or
Press RUN to tab using Job 2.
Status: Setup
Tab Stamp Fwd Stamp Rev EXIT
ƒ When using the Auto Positioning mode,
you need to select Stamp Fwd, if you are
applying stamps at the trailing edge of the
mail piece; or Stamp Rev, if you are
applying a stamp at the leading edge of the
mail piece.
Note: When using stamps, the Backing type should be set to opaque.
Applying Multiple Stamps
Multiple stamps should be treated the same as applying a single stamp, described above, except
for the following:
ƒ Select # Tabs 2 or 3.
ƒ When using the Manual Positioning mode,
you need to select the Together soft key
instead of the Separate soft key.
This permits you to apply up to two or
three stamps together (next to each other)
on the media. Choose tab placement
Status: Setup
Separate Together EXIT
Note: When using stamps, the Backing type should be set to opaque.
41