Rena T-750 - Manual (Page 39)

SETUP AND OPERATION
Press Pitch to enter Tab pitch, or
Press Opaque or Clear for Backing type.
Current liner type is: Opaque
Opaque Clear Pitch EXIT
10. In this example, the tab stock is translucent, with
a black line (space) between each tab. This is
considered a “Clear” liner type. Press the Clear
soft key.
Select option to edit, or
Press RUN to tab using Job 2.
Status: Setup
# Tabs Length Backing EXIT
11. Press the Backing soft key again.
12. Press the Pitch soft key.
|
Press Pitch to enter Tab pitch, or
Press Opaque or Clear for Backing type.
Current liner type is: Opaque
Opaque Clear Pitch EXIT
13. Enter the Tab Pitch using the numerical keypad.
In this example, the tab stock is a 15/16” round
tab with a 1/16” space between tabs, so the pitch
(measured from top of tab to top of next tab) is
1”. For the machine to work properly, you must
set the pitch for 0.010” larger than this
measurement. In this case you would type in
1.010” as the Pitch, and then press the SAVE
key.
Enter tab pitch and press SAVE key.
0.0” Current Value: 1.010”
EXIT
14. Press the EXIT soft key 5 times to get back to the “Startup Screen”
Press RUN to tab using Job 2.
Pieces: 2
Mode Pass-Thru Advanced
15. Press the Advanced soft key.
16. Press the V Tab soft key.
Status: Advanced
V-Tab Backlight More… EXIT
39