Rena T-750 - Manual (Page 24)

SETUP AND OPERATION
Programming the Job (Menu Features)
Before you can run the T-750, you must program the tabber for the following:
ƒ Number of Tabs/Stamps you plan to apply to each piece.
ƒ Media Length (When using Auto Position feature).
ƒ Backing Type (Clear or Opaque)
ƒ Tab Pitch (Distance from top of tab, to top of next tab.)
ƒ V-Tab (tab sensor voltage settings)
Start-Up Screen
The Start-Up screen will appear when you turn the tabber on.
The soft keys at the bottom of the display control the following functions:
ƒ Mode – Pressing this soft key will bring you to the mode selection screen, which allows you to
select the tab/stamp positioning mode. See “Mode Features”.
ƒ
Pass-Thru / Operate – Pressing this soft key
will cause the tabber to toggle between the “pass-
thru” mode and the “operate” mode.
When Pass-Thru is showing, for this soft key,
the tabber is in the operate mode.
The operate mode is used to tab pieces as they
are fed through the system.
When Operate is showing, for this soft key, the
tabber is in Pass-Thru mode. The pass-thru
mode can be used during the setup process to
check for correct material transport adjustments.
The pass-thru mode is also useful if the tabber is
being used in-line with other equipment. This
mode can be used to pass media through to the
next device; if the customer doesn’t want to tab
the job.
Press RUN to tab using Job 1.
Status: Pieces: 0
Mode Pass-Thru Advanced
Press RUN for pass-thru mode.
Status: Pieces: 0
Mode Operate Advanced
ƒ
Advanced – Pressing this key will place the tabber in the advanced mode. This mode is used to
set the V-Tab “tab sensing values/voltages” and to access other advanced settings and test
routines. See “Advanced Features”.
Mode Features
When the Mode soft key is pressed; the soft keys at the bottom of the display control the
following functions:
ƒ Job # - This soft key is used to select one of four programmable jobs.
ƒ Auto Pos. – This soft key is used to select the
Automatic Tab/Stamp Positioning feature.
Select program mode Job# or Automatic.
Status: Mode
Job # Auto Pos. EXIT
ƒ EXIT – Brings you back to the previous
screen/selections.
T-750 Tabber Operations Rev. 3/4/08 24