Remotec ZTS-110 V3.14 - Manual (Page 7)

7
Installation Location:
The Thermostat is restricted to be used in indoor only. It should be mounted on an inner wall about
1.5m (5ft) above the floor at a position where it is readily affected by changes of the general room
temperature with freely circulating air. Avoid mounting above or near hot surfaces or equipment
(e.g. TV, heater, refrigerator). Avoid mounting where it will be exposed to direct sunshine, drafts,
or in a laundry room or other enclosed space. Do not expose this unit to dripping or splashing
liquids.
Physically Installing the Thermostat:
1. Open the ZTS‐110 by pulling the two sections apart (Figure 2). Use the fingertips of one hand to
grip the tab on the front housing.
2. Apply power to the thermostat:
a) For battery power, install four AA batteries (alkaline recommended). Match the polarity
of the batteries with the +/‐ marks inside the battery compartment.
b) For 24Vac power, connect the wires as described in "Wiring"
3. Insert the two included wall anchors into the wall, aligned with two of the mounting holes in
the back housing of the thermostat.
4. Fasten the back housing to the wall using the two included mounting screws. Insert the screws
through the mounting holes in the housing and into the wall anchors. (Figure 3)
5. Align the front housing of the thermostat with the back housing and push until the housing
sections are locked together.
Figure 2. Open ZTS‐110
Figure 3. Install the front housing