Remotec ZTS-110 V3.14 - Manual (Page 22)

22
Press “Prog” key once to confirm
the setting.
4
Press Up/Down key to adjust auto
cool set point temperature in
AUTO COOL mode.
Press “Prog” key once to confirm
the setting and go back to Home
page.
Setting Schedule
Below are the recommended settings for different schedule scenarios:
Schedule scenarios ZTS‐110 Easy
mode setting ZTS‐110
schedule Remark
Gateway controller does
have an independent
thermostat schedules.
Enable Easy mode
(Refer to
“Activate/Deactivate
Easy Mode” section)
Schedule function
will be disabled.
Schedule function will
be controlled by
gateway.
(User should setup
the schedule function
in gateway)
Gateway controller does
NOT have an independent
thermostat schedules.
Disable Easy mode
(Refer to
“Activate/Deactivate
Easy Mode” section)
Schedule function
will be enabled.
(Refer to
“Pre‐defined
Schedule” for the
default settings.
User can adjust it
according to
personal
preference.
Schedule function will
be controlled by
ZTS‐110.