Remotec ZTS-110 V3.14 - Manual (Page 31)

31
is included into Z‐Wave
network;
Note:
After Z‐Wave inclusion process, if you reset ZTS‐110 to default while both 24Vac and batteries are
applied, ZTS‐110 will take 24Vac as primary power source and self‐configure to Always Listening Mode.
If you are using battery as back up, and the AC power is down, the battery will drain very fast, battery
will only survive 3‐5 days.
Z‐Wave Add (Include) / Delete (Exclude) into/from Z‐Wave network
Add (Include) ZTS‐110 to Gateway / Controller Z‐Wave network
Symbol Inclusion and Exclusion Mode Key Description
Add (Include) / Delete (Exclude)
Step Procedure / Description LCD indication
1
Gateway / Controller device should
be set to inclusion mode.
Press and hold “Home” key for 2
seconds to set ZTS‐110 to Add
(Include) / Delete (Exclude) Mode.
2
Press “Prog＂ key once, it will
search the network.
3
If the ZTS‐110 is added into the
network successfully, the signal of
“done” will appear.