Remotec ZTS-110 V3.14 - Manual (Page 30)

30
Mode, because reset to default process will automatically exclude ZTS‐110 from the Z‐Wave
network. You should disconnect the power source and re‐apply the power so ZTS‐110 can detect
the power source type and self‐configure to corresponding mode.
Remark:
‐ If you are using battery and somehow it is in Z‐Wave Always Listening Mode, or if you are using
battery as back up, and the AC power is down, the battery will drain very fast (battery will only
survive 3‐5 days).
‐ Regardless the FLiRS mode or Always Listening Mode, the setup and operations are same, and you
can also use local control while is it included to Z‐Wave network.
Check FLiRS / Always Listening mode in ZTS‐110
Step Procedure / Description LCD indication
1
During normal operation,
press and keep holding the
keys on “Fan” + “Mode” +
“Prog” for 3 seconds.
(The unit will resume to
normal operation after
released all keys.)
•
If the LCD displays “bt”, the
unit is detected to be FLiRS
mode if it will be included
into Z‐Wave network;
•
If the LCD displays “AC”, the
unit is detected to be
Always Listening mode if it
will be included into
Z‐Wave network;
•
If the LCD displays “bt” +
“RF icon”, the unit is in
FLiRS mode and is included
into Z‐Wave network;
•
If the LCD displays “AC” +
“RF icon”, the unit is in
Always Listening mode and