REMKO WPM-Smart-Control-Manual for specialists-WKF-085 - Manual (Page 38)

4.2 Template hydraulic diagrams with installation parameters
NOTICE!
The following template hydraulic systems are only to be used as a planning aid, and do not replace an
installation drawing! Technical modifications reserved!
The design and planning of customer-provided hydraulic systems must be performed by a specialist
installer!
We recommend adapting plant-specific parameters, such a heating limits and bivalence point, to the
design data!
You can find further hydraulics examples at www.remko.de
Hydraulic diagram for heat pump assembly WKF Köln
Functions: heating or cooling, operating mode: monoenergetic or bivalent alterna-
tiveOnly one cycle is possible for cooling; active cooling or floor heating (passive cooling)
The operating mode here can only be monoenergetic or bivalent alternative!
A
B
C
D HK FB KK
B AB
A
HGM HGU
Fig. 67: Example hydraulic diagram for HP assembly WKF Köln
A: Outdoor unit
B: WFK indoor unit
C: Storage tank
D: Second heat generator (max. 20 kW)
FB: Floor heating cycle
HK: Heater heating cycle
KK: Cooling cycle
REMKO Smart WP MANAGER
38