7 replacement of the pump, Replacement of the pump – REMKO HGM-HGU User Manual
Page 19
4
3
5.
Use the indent on the adapter as the refer-
ence point.
6.
Align the indent of the adapter (3) so that it
corresponds to value 10 on the mixing valve.
7.
Install the actuator (1) in the position as
shown in the diagram and fix everything with
the locking screw.
8.
Install the actuator cable and the heating
cycle circulation pump on the regulator of the
heat pump.
You can obtain information about the ter-
minal connections from the installation
instructions of the heat pump in the "Terminal
connections/legend" chapter.
4.7
Replacement of the pump
The pump groups are constructed in such a way
that pumps of different types and brands can be
connected. If pumps and cable connections from
other manufacturers are to be used, minor
changes to the insulation may be required. These
can be made by the installer.
19