REMKO HGM-HGU - Manual (Page 13)

4 Installation and assembly
4.1 Installation
CAUTION!
Each individual hydraulic component must be
installed by qualified personnel because the
high temperatures and pressures of the liquid
can cause personal injury.
Possible installations are:
n Wall installation
n Installation on the distributor
4.2 Wall installation
CAUTION!
You must adhere to the distance between the
piping and the wall specified in point 7.
1. Remove the pre-installed pump group from
the packaging.
2. Open the insulation cover half-shells by
pulling the front side (1) and the rear side (2)
apart.
2
1
3. Remove the insulation (3).
3
4. Remove the inlet (4) and the return flow (5).
5. Cut out the openings on the rear side of the
insulation (2).
2
13