REMKO ML 260 - Manual (Page 9)

9
Manual operation
The unit can be manually operated if, for example, the
infrared remote control is not functioning properly or
has been lost.
Open the air inlet grille of the indoor unit and press the
button on the right side.
The following operating modes are then activated:
MODE = Automatic (Operating cycle of the compressor
On → 20 min. Off → 10 min.)
TEMP. = 24°C, FAN = Automatic
SWING = On, TIMER = Off.
Shutting Down the Unit
Temporary shutdown
1. Let the unit run in cool mode for 30 minutes at a
temperature setting of 31°C.
2. Switch the indoor unit off using the remote control.
3. Disconnect the system with the main switch or fuse
protection from the power supply.
4. Check the indoor unit for visible damage.
5. Clean the indoor unit as described in the
“Maintenance and Service” section.
6. If possible, cover the outdoor unit with a plastic
sheet to protect it from weather conditions.
Permanent shutdown
For environmental safety reasons, the air conditioners
may only be disassembled by authorised service cen-
tres.
Manual air distribution
There are individually adjustable air directing plate fins
on the air outlet side for horizontally distributing the air.
Set the air directing plate fins in the desired position
with the left and right adjustment levers.
*
Never adjust the fins when the unit is in automatic
swing mode! Do not reach into the unit!
There is a risk of injuring your hand on the fan
motor.
LED display on the indoor unit
POWER On / Off (red)
PROTECT Compressor protection (green)
RUN Compressor
mode (green)
TIMER Timer mode (yellow)
Display Room temperature / target temperature
error code
The display changes to the target temperature display
when the settings are made with the remote control.
Left adjustment
lever Right adjustment
lever
Cause
E3 RUN and TIMER LEDs blink alternately.
Unit switches off after approx. 30 seconds.
Fan motor
E5 TIMER LED blinks. Room air sensor
E6 RUN LED blinks. Frost protection
sensor
E9 The LEDs blink alternately for 20 minutes.
Unit switches off after another 20 minutes.
Insufficient refriger-
ant
LED error code
First, remedy the cause of the problem and then reset
the error code display by switching the unit off and off.
Malfunction display
1 Indoor unit ML ...-IT
2 Outdoor unit ML ...-AT
3 Infrared remote control
4 Refrigerant pipes
5 Air inlet grille
6 Air outlet fin with swing motor
7 Manual air directing plate fin
(covered)
System Structure
11
3
4
7
8 9
Outside
Inside
2
1
14
12
10
13
6
15
5
8 Display
9 Receiver
10 Manual mode switch
11 Condenser
fan
12 Wall lead-through
13 Shut-off valve
14 Condensation connection ML ...-IT
15 Air
outlet