REMKO ML 260 - Manual (Page 6)

6
Button functionality
The following settings can be made using the remote control at a distance of no more than 7m. Point the remote
control at the receiver on the right side of the indoor unit. The unit beeps to confirm that a button has been pressed
and the signal has been correctly received.
By pressing the CLOCK button inside the battery slot, the time is programmed.
“CLOCK” blinks on the display and the current time is set using the HR. and MIN. but-
tons. Pressing the CLOCK button again closes the programming function and the dis-
play no longer blinks. CLOCK button
Functional process
CLOCK HR./ MIN. CLOCK
By pressing the ON / OFF button, the air conditioner is activated or deactivated. The
settings and setting values programmed before the unit was last switched off appear
on the display. ON / OFF button
Functional process
ON/OFF ON/OFF
By pressing the RESET button inside the battery slot, the remote control can be reset .
Then, the time must be programmed (see “CLOCK” button). RESET button
Functional process
RESET 5 sec. Time setting
buttons The button reduces the desired target temperature and the button increases the
target temperature. This setting is only possible in cooling mode. In automatic mode,
the button decreases the fixed temperature by 1°C and the button increases the
fixed temperature by 1°C. It is not possible to set the temperature. In dehumidifying
mode, the temperature cannot be set.
Functional process
Cooling mode
Automatic mode
The display
disappears
after 1 min .
The blinking dot on the remote control
indicates that the remote control is ready
for use.
A symbol on the display shows that the
settings are being transmitted.