REMKO ML 260 - Manual (Page 7)

7
Automatic mode In automatic mode, the control mechanism operates in cooling mode.
A target temperature of 24°C is permanently set. The range lies between 22°C and 26°
C. This can be increased or decreased by 1°C with the buttons.
Functional process
Functional process
COOLING MODE
MODUS
Cooling mode In cooling mode, the room air is cooled to the set target temperature. The desired room
temperature is set in 1°C increments with the buttons. If the temperature is
1°C above the set target temperature, the indoor unit begins to cool the room air. If the
room temperature falls approx. 0.5°C below the set room temperature, the control
mechanism switches cooling mode off. To protect the compressor, the control mecha-
nism is first reactivated after 3 minutes have elapsed.
Dehumidifying mode In dehumidifying mode, the room temperature is decreased to 24°C. Due to the low
temperature of the refrigerant, the temperature of the fin exchanger falls below the dew
point of the air. The excessive moisture in the air condenses on the fin-exchanger and
the room is dehumidified. The fan speed should be set to automatic to reach maximum
dehumidification capacity. In automatic mode, the fan switches on and off at intervals.
DEHUMIDIFICATION MODE
MODUS
Functional process
Heating mode This mode is not available.
Mode button Use the MODE button to select the individual operating modes. There are 4 modes
available:
1. Automatic, automatic selection of cooling or heating mode
2. Cooling, operating mode primarily for summer
3. Dehumidifying, summer or winter operating mode
4. Heating, not available
Functional process
MODE MODE MODE MODE
Automatic Cooling Dehumidifying Heating
MODE
COOLING MODE
FAN button The fan speed is selected with this button. You can select either low, medium, high or
automatic fan speed.
Functional process
FAN FAN FAN FAN