REMKO WLT 25 - Manual (Page 8)

Key functions
To enter the circulation mode, actuate the "MODE" key once or several
times until the FAN indication is shown in the display. In this mode,
the unit is used as an air circulation unit. The room is neither heated nor
cooled.
Use the "COOL" mode if you wish to cool the room down to the desired
temperature.
Reduce the temperature in 1 °C steps by actuating the "qTMP" key.
After the beep the COMP display starts to flash for approx. 3 minutes.
This waiting time is required to allow the valve assembly to open
completely. If the indicator is shown constantly then the air conditioning
unit has started its work. If the temperature falls to approx. 2 °C below
the set room temperature, the controller will switch off cooling mode.
MODE key
Use the "MODE" key to select between the individual operating modes.
A total of 5 modes are available:
1. AUTO Automatic mode, automatic selection of cooling
or heating mode
2. FAN Circulation mode, no cooling or heating capacity
3. COOL Cooling mode, mainly used in summer
4. DRY Dehumidification mode, summer or winter mode
5. HEAT Heating mode, mainly used in winter
MODE
COOLING MODE
MODE MODE MODE MODE
AUTO mode
To enter the automatic mode, actuate the "MODE" key once or several
times until the AUTO indication is shown in the display.
In this mode, the controller automatically selects COOL or HEAT mode
depending on the temperature. The temperature is then maintained at
the set value.
It is also advisable to set the FAN setting to FAN AUTO.
COOLING
or
HEATING
Set temperature is
below the room temperature
Set temperature is
above the room temperature
MODE FAN
q TMP
or
p TMP
FAN mode
MODE
COOL mode
CIRCULATION MODE
FAN
MODE
q TMP
or
p TMP
REMKO WLT
8