REMKO WLT 25 - Manual (Page 18)

Electrical wiring
All electrical installation work
is to be performed by specialist
companies. Disconnect the
power supply when connecting
the electrical terminals.
CAUTION
■ We recommend the customer
installing a main / repair switch
on the building close
to the indoor unit.
■ The power supply is made at
the indoor unit, a control line to
the chiller is not necessary.
■ If a condensate pump, which
is available as an accessory,
is used in conjunction with
the unit, the pump switch-off
contact switches off the power
supply or the valve if necessary.
■ The terminal blocks for making
the connections are located
behind the cover on the right
side of the indoor unit.
Make the connection as
follows:
1. Open the air inlet guard.
2. Loosen the cover on the right
side.
3. Connect the unit with the
power supply.
See electrical drawings.
4. Re-assemble the unit.
Electrical drawings
WLT 25 / WLT 27
WLT 45 / WLT 55 /
WLT 75 / WLT 85
Check all plugged and
clamped terminals to verify
they are seated correctly and
make a permanent contact.
Tighten as required.
CAUTION
REMKO WLT
18