REMKO WLT 25 - Manual (Page 12)

Shutdown
Temporary shutdown
1. Let the unit run for 2 to 3
hours in circulation mode, or
in cooling mode at maximum
temperature, to extract any
residual humidity from the unit.
2. Shut down the system using
the remote control.
3. Switch off the electrical power
supply to the unit.
4. Check the unit for visible
signs of damage and clean as
described in the chapter "Care
and maintenance"
Permanent shutdown
Ensure that units and components
are disposed of in accordance with
local regulations, e.g. through
authorised disposal and recycling
specialists or at collection points.
REMKO GmbH & Co. KG or your
contractual partner will be pleased
to provide a list of certified firms
in your area.
Care and maintenance
Regular care and maintenance
ensure the trouble-free operation
and long service life of the unit.
Type of task
Checking / Servicing / Inspection
Commissioning Monthly Half-yearly Yearly
General •
Medium cycle bleeding • •
Check medium filling
• •
Contamination of fin heat exchenger • •
Filter contamination
• •
Check voltage and current
• •
Check function of fan
• •
Check condensate drainage
• •
Check insulation
• •
Care
■ Ensure the unit is protected
against dirt, mould and other
deposits.
■ Clean the unit using a damp
cloth. Do not use any caustic,
abrasive or solvent-based
cleaning products. Do not use
a jet of water.
■ Clean the fins on the unit prior
to long shutdown periods.
Maintenance
■ It is recommended that you
take out a maintenance
contract with an annual service
from an appropriate specialist
firm.
A maintenance contract will
guarantee that your system
always operates reliably!
TIP
Prior to performing any work,
ensure that the unit is isolated
from the electrical power
supply and secured to prevent
accidental switch-on!
CAUTION
REMKO WLT
12